Metrohm 916 Ti-Touch - Manual (Page 46)

6.1 Switching the instrument on and off
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
30 ￭￭￭￭￭￭￭￭
916 Ti-Touch
Switching off the instrument
CAUTION
The 916 Ti-Touch must be switched off by pressing the mains switch on
the rear of the instrument before the electricity supply is interrupted. If
this is not done, then there is a danger of data loss.
Proceed as follows:
1 ￭ Press the mains switch on the left-hand side of the rear panel of
the 916 Ti-Touch.
The current data is saved and the system is shut down. This process
takes just a short time. At the same time, all other devices connected
to the 916 Ti-Touch via a USB cable are also being switched off.