Metrohm 916 Ti-Touch - Manual (Page 286)

27.6 USB Sample Processor
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
270 ￭￭￭￭￭￭￭￭
916 Ti-Touch
2 Assign the lift position
￭ Tap on [Assign lift pos.].
The dialog Lift / Assign lift position is displayed.
￭ Select the desired specific lift position and tap on [Assign].
The current lift position is assigned to the specific lift position.
27.6.2 Moving to a rack position
Manual control: Sample Processor ▶ Rack position
In the dialog Sample Processor / Rack position, you can move to any
position on the attached rack.
Current rack pos.
Current rack position. If the rack is not set to a valid position, e.g. after a
rack reset, -- is displayed to indicate this.
Rack position
Desired rack position.