Wasp Barcode Inventory Control User Manual
Page 368
InventoryControl Printable Help
Press ESC to Exit the error message and then provide the required Location value.
Note: If the Allow Negative Quantities on Mobile Devices option is disabled, you will see a
warning message if you attempt to Remove quantity from a Location that does not exist in the
PDT database. The Allow Negative option must be set on the PC prior to creating the database.
You can check the state of this option on the PDT by using the 7 key on the Main Menu to go to
the PDT About screen.
New Locations can only be created during Remove when the Allow Negative Quantities on
Mobile Devices option is enabled. If you are prompted to confirm a new Location that you
believe should already exist in the database, press ESC to cancel, then return to the Main Menu
to check Site Config. If the Location you entered exists only at a Site other than the currently
selected Source Site, InventoryControl must treat that value as a new Location for the Source
Site. Select a different Source Site in Site Config if that's where you intended to perform this
transaction.
The Allow Negative Quantities option applies to batch devices only. Mobile devices that
are communicating with the database via a wireless connection will not allow negative
quantity transactions regardless of the option settings.
4. Enter
a
Customer Number, then press F4.
Remove
123
Monitor
Customer:
00001
ESC=Cancel
F1=Prev F4=Next
A Customer value might be required for this Item #. If not, the Customer field can be left empty
or a value may be entered optionally.
As shown below, if a Customer value is entered that's not currently in the PDT database, you will
be prompted to accept or reject the entry as a new value to be added to the database. The
currently selected
Source Site
will be displayed when you are about to create a new Location.
Customer:
ACME
New entry. Press Ent
To accept or ESC to
Cancel.
ENT=OK
ESC=Cancel
5. If
this
Item does not have Tracked By enabled for the Date Code, Pallet or Lot fields, a screen
like the one below will be shown, prompting the entry of Qty.
Remove
100007
Paint Can
Qty:
ESC=Cancel
353