IAI America XSEL-S - Manual (Page 59)

Chapter 2 Operations
51
2.3.3 Setting of Extension Motion Control Board Parameters
x Displaying the Extension Motion Control Board Parameter Setting window
Start the PC Software for X-SEL and click Controller, Ex Motion Control Board (X), and then
Parameter (P).
Select Dev/Table No.
Select Parameter.
Select Dev No.
A device No. indicates the position of a extension motion control board,
as the ordinal number from the leftmost I/O slot of the controller.
Device No. becomes 0 if single extension
motion control board is used.
Left side: Device No. 0 Right side: Device No. 1