IAI America XSEL-S - Manual (Page 47)

Chapter 2 Operations
39
Chapter 2 Operations
2.1 Operation Procedure
Set parameters and create a program according to the following procedure.
[1] Setting of RC controller parameters
o See section 2.2.
[2] Setting of XSEL controller parameters
o See section 2.3.
x I/O parameter setting
x Pulse I/O board common parameter setting
x Pulse I/O board input channel parameter setting
x Pulse I/O board output channel parameter setting
To use the electronic
CAM function
[See section 2.4.]
To use the electronic
shaft function
[See section 2.5.]
To use the
positioner function
[See section 2.6.]
To use the input pulse
counter function
[See section 2.7.]
[3] Electronic CAM
data edition
o [See section 2.4.5.]
[3] Position data edition
o [See section 2.6.2.]
[4] Program edition
[See Chapter 3.]