IAI America XSEL-S - Manual (Page 196)

Chapter 6 Operations of X-SEL
PC Software Extension Motion Control Functions
188
Clear CAM Table
If you select [Controller] o [Ex Motion Control Board (X)] o [CAM Table Clear (C)] from the menu,
the Select Dev/Table No. dialog box (Figure 2.24) appears. Select a device number and table
number and click [OK] to clear CAM tables.
Figure 2.24. Select Dev/Table No.
(Clearing CAM Tables)
Memory Initialization of Extension Motion Control Board Settings
At parameter initialization: Select [Controller] o [Ex Motion Control Board (X)] o [Initialize
Memory] o [Parameter (P)] from the menu (Figure 2.25).
At CAM table initialization: Select [Controller] o [Ex Motion Control Board (X)] o [Initialize
Memory] o [CAM Table (T)] from the menu (Figure 2.26).
Figure 2.25. Menu (Initialization of Extension Motion Control Board Memory)
The memory initialization confirmation dialog box (Figure 2.26) appears. Select a device number and
then click [OK] to initialize the memory.
Figure 2.26. Memory Initialization Confirmation Dialog Box