Luminex 100 IS Version 2.2 - Manual (Page 71)

x MAP Technology Using Luminex 100 IS 2.2 Software
PN 89-00002-00-069 Rev. A 6 - 17
Figure 28. Command List Dialog Box
2. Select the command that you want to add to your Favorites list.
3. For certain commands, select the location where you want to
draw or expel fluid. You do this using the location drop-down
arrow and clicking over the microtiter plate location on the
image. See Figure 29. The rectangular box in the upper right
corner represents the reservoir.
To change the location where the system draws or expels fluid,
the software allows you to modify the well location as you
confirm the initiated command.
4. Click OK to add the command. The command is displayed in the
Favorites List.
Figure 29. Microtiter Plate Image
Remove Items
From Favorites
‹ To remove items from the Favorites list:
1. Select the item you want to remove from the Favorites list.
2. Click Remove. The item disappears from the Favorites list.
Note: Ensure that the location
you select is compatible with the
volume intended for that location.
The location’s capacity may vary
depending on the microtiter plate
sizes used. Refer to the
specifications in Chapter 3 for
additional information.