Luminex 100 IS Version 2.2 - Manual (Page 176)

Luminex 100 IS User Manual Version 2.2 x MAP Technology
6 - 122 PN 89-00002-00-069 Rev. A
6. Click the drop-down arrow to the right of the Eject/Retract
button. An image of the microtiter plate and reservoir appears in
the plate holder. See Figure 121.
Figure 121. Microtiter Plate Image For Location Selection
7. Select a well location to draw fluid from using the image of the
microtiter plate and reservoir, then click Eject/Retract. The
plate holder ejects.
8. Place 200
µL of distilled water into selected well location
.
9. Click OK to continue. The Message Log on the Diagnostics tab
indicates that the command started. The Device Activity box on
the Status Bar indicates that the system is soaking. Wait until the
soak command completes before initiating another command.
Upon completion, the microtiter plate representation shows a
green well with a check mark to indicate the command’s success
or a red well with an X mark to indicate the command’s failure.
Exit Luminex 100 IS
2.2 Software
When you exit the system a confirmation dialog box prompts you to
verify that you really want to exit the system.
‹ To exit the system:
1. From the file menu, select Exit. An Exit dialog box appears
prompting to make sure you want to exit the system. See
Figure 122.
Figure 122. Exit System Verification Dialog Box
2. Click Yes. The Luminex 100 IS 2.2 software closes.
Note: The system may show a
default location from which to draw
fluid. In this case, the microtiter
plate shows that well with a yellow
line outlining the well.