Luminex 100 IS Version 2.2 - Manual (Page 221)

x MAP Technology Installation
PN 89-00002-00-069 Rev. A A - 15
Figure 146. Modify, Repair, or Remove Dialog Box
Network Installation
Advisory
This section is intended for your network IT representative. If you
are installing your system on a network be advised not to change the
computer name or the Luminex 100 IS 2.2 database will fail. If you
must change the name, then perform these steps:
‹ To change the computer name on Luminex 100 IS 2.2 systems:
1. Change the computer name following the MS Windows process.
2. When you reboot the system an error message appears warning
about database errors.
3. Reinstall Luminex 100 IS 2.2 software using the Repair option.
After the reinstall the database is available; you do not need to
reboot.
Prepare System for
First Use
After you install the hardware and software, you need to run the
following commands to prepare the system for first time use. Also,
consider running these commands when the system has been idle for
extended periods of time. Refer to “At the Maintenance tab you
perform maintenance commands, XYP commands, and calibration
and verification commands during system use. See Figure 35.” on
page 6-24 for command operation. Run the following commands in
order:
• 2 Backflushes
• 2 Drains
• 2 Alcohol flushes
• 3 Washes with water