Luminex 100 IS Version 2.2 - Manual (Page 153)

x MAP Technology Using Luminex 100 IS 2.2 Software
PN 89-00002-00-069 Rev. A 6 - 99
Choose from two sorting methods:
Sequentially (by order acquired). This feature arranges sample
data progress beginning with data acquired from the first sample in
your batch and continues chronologically until the last sample with
the AVG section at end.
Alphabetical (by sample ID). This feature arranges sample data
progress alphabetically according to the sample, beginning with A to
Z, then one through nine. The AVG results are listed above the
individual sample results.
Errors Tab
The Errors tab displays a list of errors that occurred during
acquisition. See Figure 90. It organizes the errors in two categories:
• System and assay errors (top section of tab)
• Sample errors (bottom section of tab)
Table 6 lists the errors in each category.
Table 6. Error Categories
System and Assay Errors Sample Errors
• Instrument Not Calibrated
• Failed Verification (system
lists each failed control)
• Failed Control (verifier
failed)
• Temperature Divergence
from Calibration
Temperature
• Failed Curve Fit
• Unknown Diagnostic Error
• APD Temp Range
Exceeded
• XYP Temp Unstable
• Low Voltage
• High Sheath Pressure
• Low Sheath Pressure
• Command Timeout
• Low Laser Power
• Unknown Formula Failure.
• Insufficient Bead Count
• Sample High/Low
• Diagnostic Error
• High Sheath Pressure
• Low Sheath Pressure
• Sample Timeout
• Sample Empty