Luminex 100 IS 2.1 User Installation Guide - Manual

PN 89-00002-00-105 Rev. A 1
Luminex
®
100
™
IS 2.1 User Manual
Installation Guide
Follow these instructions to install the Luminex 100 IS Version 2.1 user manual
from the user manual CD provided with this document.
Overview
The Luminex 100 IS User Manual and the Luminex 100 IS
Developer Workbench Guide are provided on a CD in electronic
form as PDF files. These files are viewed using Adobe
® Reader ®,
which is provided on the CD. Available translations are also included
on the CD.
• If you are just updating the documentation on an existing
(previously installed) PC or laptop, continue with the section
“Install User Manual from CD” on page 5.
• If this is a new system installation, you have to first connect the
system components using the following brief instructions, then
install the documentation. Note that the complete system
installation instructions are provided in the user manual that is
loaded from the CD. Continue with the following “Luminex 100
IS System Hardware Setup” section.
Contact Luminex Technical Support if you have any problems with
the setup. Refer to “Luminex Technical Support” on page 6 for
details.
Luminex 100 IS
System Hardware
Setup
Before connecting the system components, ensure that the facility
complies with all system and safety requirements. For system
specifications, refer to “Luminex 100 IS System Specifications” on
page 7. Position the instrument to minimize temperature fluctuations.
Figure 1 shows placement of the system components. The following
sections describe how to connect the Luminex 100 IS system
hardware components and install the documentation:
1. “Connect System Components” on page 2
2. “Power On PC Components” on page 5
3. “Install User Manual from CD” on page 5
Note: Hardcopy versions of
the user manual may be
ordered through the Luminex
website or the Luminex Order
desk.
Note: Installing the user
manual on a new system
requires that the system be
setup (connected) before
installing the user manual.