Luminex 100 IS Version 2.2 - Manual (Page 145)

x MAP Technology Using Luminex 100 IS 2.2 Software
PN 89-00002-00-069 Rev. A 6 - 91
2. Select the desired batch to analyze and click Select. The
Analysis window appears showing the progress as the system
opens the batch and analyzes the data. See Figure 80. Each test
displays “Analyzing” as the system calculates.
3. Select the desired test or analyte to view from the Standards tab.
The system displays this analyte in detail. Switch between tabs to
observe the tests errors under the Errors tab and unknown results
under the Samples tab.
To select the next test in the batch click Next Test (F2). To
select the previous test, click Previous Test (F3). You may also
click on the test name in the left grid control.
Standards Tab
The Standards tab lists all the batch tests with system comments
specific to each test. The detailed test information that is displayed
on the three tabs, of the Analysis window, is determined by the test
selected under the Standards tab. See Figure 82.
The Standards tab displays the quantitative batch’s standard curve. It
displays qualitative batches as a graph plotting the assay standard.
Above the graphical information, the tab displays the formula that it
used to calculate batch data.
Below the graphical information, the tab displays the Standards and
Controls values for the selected test.