Luminex 100 IS Version 2.2 - Manual (Page 126)

Luminex 100 IS User Manual Version 2.2 x MAP Technology
6 - 72 PN 89-00002-00-069 Rev. A
Figure 67. Luminex Batch Setup for Dilution
4. Click the Dilution Factor field. The white indicates that you can
enter text into the field.
5. Enter the dilution factor used if the factor is other than one.
Enter each dilution factor as a decimal, not as a ratio.
6. Click Finish. The system saves the information you entered.
Copy Batch
Information to
Clipboard
You can copy the following information to the clipboard:
• At the Run Batch Tab, the four columns in the batch command
list
• At the Run Batch tab, the microtiter plate image
• At the Diagnostic tab you can copy the Message Log
‹ To copy information from the current batch:
1. Click over the desired area to copy.
2. Press the Ctrl+C keys on the keyboard or right-click and select
Copy from the dialog box.
3. At the Command Information dialog box, click OK. The
information is copied to the clipboard. If you copy the microtiter
Note: The system does not
allow you to copy or paste
information while interpreting
or analyzing data.