AMETEK ReFlex - Manual (Page 90)

ReFlex Power™ AC Power Supplies
M380056-01 Rev K 4-5
Figure 4-2. Rear View of Typical AC Supply Module
4.3 SPECIFICATIONS
All specifications are valid after a 30-minute warm-up time. Module could be used
at reduced accuracy immediately following power-on. All accuracy specifications
are plus/minus variations around the nominal parameter values, unless otherwise
noted. Unless otherwise specified, requirements apply at the front panel output
terminals, over the entire programming range, and with remote sense connected
to front panel terminals. Performance specifications are valid following calibration
at 25 °C, +/- 5
°C.