AMETEK ReFlex - Manual (Page 327)

Active Loads ReFlex Power™
7-52 M380056-01 Rev J
7. After DC voltage. Enter the voltage using SCPI commands
CAL:INP:VOLT 2
8. After DC current. Enter the current using SCPI commands
CAL:INP:CURR 2
9. Send the calibration command to calculate the gain and offset
CAL:INP:COND:CALC
10. Send the system error query command to make sure calibration was
successful.
SYST:ERR?
11. If there is no error returned at the system error query command then
save the calibration result with the following command
CAL:UNLOCK “6867”
CAL:STORE
CAL:LOCK
12. Reset the unit
*RST