AMETEK ReFlex - Manual (Page 282)

ReFlex Power™ Active Loads
M380056-01 Rev J 7-7
7.2.4
P
ROGRAMMABLE
F
UNCTIONS
The Active Load module can be programmed several variables:
• Input Current
•
Resistance
• Over Power Protection
• Over Voltage Protection
•
Over Current Protection
7.2.5
R
EADBACK
F
UNCTIONS
• Input Current
•
Input Voltage
• Power
• Over Power Protection value
•
Over Voltage Protection value
• Over Current Protection value
7.3
SPECIFICATIONS
All specifications are valid after a 30-minute warm-up. Modules could be used at
reduced accuracy immediately following power-on. All accuracy specifications
are plus/minus variations around the nominal parameter values, unless otherwise
noted. Unless otherwise specified, requirements apply at the front panel output
terminals, over the entire programming range, and with remote sense connected
to front panel terminals. Performance specifications are valid following calibration
at 25 °C, +/- 5 °C
7.3.1 P
RODUCT
M
ATRIX
Model
Voltage
Full-Scale
Rating
Current
Full-Scale
Rating
Power Rating Module Width
HPAL 500V 30A 750W Triple, 4.2”
LPAL 500V 15A 375W Triple, 4.2”