AMETEK ReFlex - Manual (Page 124)

ReFlex Power™ AC Power Supplies
M380056-01 Rev K 4-39
4.5.4
D
EFAULT
O
PERATIONAL
C
ONDITIONS
P OWER -O N C ONDITIONS
When an AC power supply module is first powered on, the following
parameters are set to factory default values:
•
Output configuration: standalone
• Output voltage: 0V
• Output current: full scale
• Overvoltage protection (OVP): 106% of full scale voltage; programmable
mode
• Undervoltage protection (UVP): 0V, programmable mode
• Overcurrent protection (OCP): 106% of full scale current; programmable
mode
•
Output state: off
• Output isolation and remote sense relays: open
• Frequency set to 60 Hz
R ESET C ONDITIONS
If a module is reset with the SCPI command, *RST[n], (where n is the module
address), the following default conditions are set:
• Output configuration: unchanged
• Output voltage: 0V
• Output current: full scale
•
Overvoltage protection (OVP): 106% of full scale voltage; programmable
mode
• Undervoltage protection (UVP): 0V, programmable mode
• Overcurrent protection (OCP): 106% of full scale current; programmable
mode
• Output state: off
•
Output isolation and remote sense relays: open
• Frequency set to 60 Hz
• All status reporting data structures are cleared. Enable-masks are not
cleared.