AMETEK ReFlex - Manual (Page 193)

Fixed Power DC Power Supply ReFlex Power™
5-24 M380056-01 Rev J
signals are available for dedicated hardware interface. All connectors for control
and power interface are accessible on the front panel
5.5.1
C
ONTROLS AND
I
NDICATORS
Figure 5-7. FPDC Indicators and Connectors
1 – Output Indicator: Green LED lights when output voltages are enabled or isolation relays
are closed
2 – Power Indicator: Green LED lights when AC/DC input power is applied to the module.
3 – Fault Indicator: Red LED lights when an abnormal internal operating condition has been
detected; the output would be disabled and the isolation relay opened.
4 – Bus Indicator: Green LED lights when internal inter-module communications has been
established.
5 – User Interface Connector for remote isolated digital enable signal.
6 – DC Output connector for the output voltages and remote sense.