AMETEK ReFlex - Manual (Page 88)

ReFlex Power™ AC Power Supplies
M380056-01 Rev K 4-3
• User programmable supervisories for current and voltage
• ACPS IVI drivers
•
2 models with Output Frequency Range 45 to 1200 Hz or 45 to 5000
Hz
•
Auxiliary Output, 22.6 % of Main 140 VAC output, 61VA (low range,
350-1000 Hz), 2A maximum
•
Two ranges on output, 0-140VAC, and 0-280 VAC
• Direct-Coupled output
• Measurement capabilities of: V
RMS
, I
RMS
, Frequency, Phase, I
pk
(versions 2.0 and 3.0) and Active Power, Apparent Power, Reactive
Power, Power Factor, Crest Factor (version 3.0 only).
• +/- 30 A
pk
, inrush current.
4.2.2 A
CCESSORIES
L
IST
The ReFlex Power™ AC power supply modules include the following standard
accessories:
•
Operation Manual, P/N M380056-01 (this manual)
• Programming Manual, P/N M380056-03
• Quick Reference Guide, P/N M380056-04
4.2.3 C
ONTROLS AND
I
NDICATORS
The AC power supply module operates within the ReFlex Power™ system as
part of an automated test system, so there are no user manual controls. They
rely on the Mainframe and Controller module for control, status and data
communications, and for input/output connections to the user application. All
output load connections and discrete control interface to the user application are
accessible on the front panel of the modules. Also, the front panel has indicators
for annunciation of the operational state. Input power is routed from the
Mainframe through a backplane distribution.
Figure 4-1 shows a front view of the 875 VA ACPS module. Figure 4-2 shows a
typical rear view of the modules with the backplane connector interface for input
power, discrete digital control signals, analog control signals, and data
communications.