AMETEK ReFlex - Manual (Page 69)

ReFlex Power™ Controller ReFlex Power™
3-6 M380056-01 Rev J
3.3 SPECIFICATIONS
Performance specifications are valid at 25 °C, +/- 5 °C.
Power On Sequence: Manually operated switch.
Power Off Sequence: Manually operated switch for a controlled power off
sequence, or a Remote Inhibit to do an immediate
power module output-off sequence.
3.3.1 S
UPERVISORY
C
HARACTERISTICS
O VERTEMPERATURE
Overtemperature protection is implemented with protection monitors that
sense excessive internal operating temperature, and will turn off all the
modules. The maximum internal temperature is typically 85 °C.
3.3.2
G
ENERAL
C
HARACTERISTICS
I NPUT V OLTAGE R ANGE
103.5-253VAC with AC input; 270VDC, nominal; 210VDC, minimum to
300VDC, maximum; 314VDC, maximum for 2s; 364.5VDC, maximum for
450ms
I NPUT C URRENT
Single-phase AC input; unipolar DC input; sinusoidal current with AC
input; continuous DC current with DC input.
At 103.5 VAC input, less than 1.7A
pk
. surge at AC power application; less
than 1.3A
pk
surge when RFPC power switch is turned on and less than
200mA RMS steady state.
3.3.3 I
NPUT
/O
UTPUT
C
ONNECTIONS
RJ-45 – host LAN
15-pin D-Subminiature female – control signal interface