AMETEK ReFlex - Manual (Page 209)

DC Power Supplies ReFlex Power™
6-6 M380056-01 Rev K
Figure 6-3. Typical Rear View (single-width model shown)
6.3 SPECIFICATIONS
All specifications are valid after a 30-minute warm-up time. Modules could be
used at reduced accuracy immediately following power-on. All accuracy
specifications are plus/minus variations around the nominal parameter values,
unless otherwise noted. Unless otherwise specified, requirements apply at the
front panel output terminals, over the entire programming range, and with remote
sense connected to front panel terminals. Performance specifications are valid
following calibration at 25 °C, +/- 5
°C.