AMETEK ReFlex - Manual (Page 174)

ReFlex Power™ Fixed Power DC Power Supply
M380056-01 Rev J 5-5
5.3 SPECIFICATIONS
All specifications are valid after a 30-minute warm-up time. Module can be used
at reduced accuracy immediately following power-on. All accuracy specifications
are plus/minus variations around the nominal parameter values, unless otherwise
noted. Unless otherwise specified, requirements apply at the front panel output
terminals, and with remote sense leads connected to front panel terminals.
Performance specifications are valid following calibration at 25 °C, +/- 5 °C
5.3.1
P
RODUCT
M
ATRIX
Model Output Current Rating Power Rating
FPDC
+5V DC 10 A 50W
-5V DC 5 A 25W
+15V DC 3 A 45W
-15V DC 3 A 45W
5.3.2
O
UTPUT
C
HARACTERISTICS
V OLTAGE A CCURACY
+5VDC and –5 VDC: +/- 52 mV
+15VDC and –15VDC: +/-200 mV
All at 25 °C, +/-5 °C
V OLTAGE R IPPLE /N OISE
(measured with 20Hz to 20MHz bandwidth)
+5VDC: 150 mV peak-peak
-5VDC: 80 mV peak-peak
+15VDC and –15VDC: 150 mV peak-peak
V OLTAGE T EMPERATURE D RIFT
0.02% of full-scale/°C, maximum
V OLTAGE L INE P LUS L OAD R EGULATION
+5VDC and –5VDC: +20 mV, -100 mV
+15VDC and –15VDC: +/- 150 mV
V OLTAGE L OAD T RANSIENT
Less than 4% deviation for a 25-75% of full-scale load step and back within DC
regulation limits after 400 usec