Metrohm tiamo 2.3 Patch 1 - Manual (Page 980)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
964 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1
Sensor
Measuring input
Selection of the measuring input the sensor is connected to.
Titrando (without 888, 890)
Selection
1 | 2
Default value 1
851, 855, 867, 888, 890
Selection
1
Default value 1
852
Selection
2
Default value 2
Sensor
Selection of a sensor of type Metal electrode from the sensors config-
ured in the sensor table. The calibration data for the sensor will be adop-
ted for the determination.
Selection Sensor name | Metal electrode
Default value Metal electrode
I(pol)
The polarization voltage is the voltage applied to the polarizable electrode
during a amperometric measurement.
Titrando, 855, 867
Range
-125.0 ... 125.0 µA (Increment: 0.5)
Default value 5.0 µA
Titrino
Range
-127 ... 125.0 µA (Increment: 1)
Default value 5 µA
Electrode check
on | off (Default value: off)
If this check box is enabled, then an electrode check will be carried out for
polarizable electrodes during the transition from an inactive normal status
to a measurement. A check is also made while doing so to ensure that the
electrode is properly connected and that no short-circuit is present.
Temperature measurement
Type of temperature measurement