Metrohm tiamo 2.3 Patch 1 - Manual (Page 1413)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 6 Configuration
tiamo 2.3 Patch 1 ￭￭￭￭￭￭￭￭ 1397
measuring input are shown in the selection list. The connection of a sen-
sor to a particular device is not checked during the run. In the case of
intelligent sensors and the Thermoprobe, the device to which the sensor is
connected is shown here automatically
Selection Device selection | 'empty'
Default value 'empty'
Measuring input
For non-intelligent sensors it is possible to select here the measuring input
to which the sensor is connected. The connection of a sensor to a particu-
lar measuring input is not checked during the run. This parameter only
appears if a Device has been chosen. For intelligent sensors and the Ther-
moprobe the measuring input to which the sensor is connected is shown
here automatically.
Selection 1 | 2
Default value 1
Comment
Possibility to enter remarks about the sensor.
Input 24 characters
Default value 'empty'
Set to work
The current date is automatically entered here for a newly added sensor.
When editing an existing sensor, the date can be selected by pressing
in the dialog window Select date (see Chapter 2.5.1, page 92).
Monitoring the sensor
on | off (Default value: off)
If this option is activated, then the working life of the sensor will be moni-
tored.
Working life
Working life of the sensor in days. If a value is entered here then the
Expiry date will be automatically adapted.
Range 0 ... 999 Days
Default value 999 Days
Expiry date
Expiry date of the sensor. The date can be selected by pressing in the
dialog window Select date (see Chapter 2.5.1, page 92). After a date
has been entered the Working life will be automatically adapted.