Metrohm tiamo 2.3 Patch 1 - Manual (Page 1279)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.3 Patch 1 ￭￭￭￭￭￭￭￭ 1263
Designa-
tion Description
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command has
never been started
.FIN Command status; 1 = Command has ended at least
once, 0, invalid (variable not available) = Command has
never ended
.TOU Timeout status: 1 = Timeout expired; 0 = Timeout not
expired
5.6.9.5.2 RECEIVE - Properties
Dialog window: Method ▶ RECEIVE ▶ Properties... ▶ RECEIVE - 'Command name'
Command name
Name of the command.
Input 25 characters
Wait for event/status
Selection Wait until all conditions are met | Wait until
one of the conditions is met
Default value Wait until all conditions are met
Wait until all conditions are met
Waits until all conditions listed in the table are fulfilled.
Wait until one of the conditions is met
Waits until one of the conditions listed in the table is fulfilled.
[New]
Open the dialog window Wait for event/status for entering a new
event message which is to be waited for (see Chapter 5.6.9.5.3, page
1264).
Note
A maximum of 10 event messages can be entered.
[Properties]
Open the dialog window Wait for event/status to edit the event mes-
sage selected in the table which is to be waited for (see Chapter
5.6.9.5.3, page 1264).
[Delete]
Delete the selected event message.