Metrohm tiamo 2.3 Patch 1 - Manual (Page 1070)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1054 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1
Designa-
tion Description
.LP.EXx External value × (1...3) for the last measuring point of
the measuring point list
.LP.CNT Intensity of the last measuring point on the measuring
point list in counts
.LP.MEA Measured value for the last measuring point of the
measuring point list in the unit of the measured value
.LP.TIM Time in s until the last measuring point in the measuring
point list is reached
.LP.TRN Transmission of the last measuring point of the measur-
ing point list in %
.MTE Temperature measurement with sensor; 1 = on, 0 =
off)
.NMP Number of measuring points in measuring point list
.STY Type of stop with which the command was stopped: 1
= normal; 0 = manual or after error
1) Command variable is invalid for the Avantes spectrometer
5.6.4.15.2 MEAS Opt Conc- General/Hardware
Tab: Method ▶ MEAS Opt Conc ▶ Properties... ▶ General/Hardware
Command name
Name of the command.
Input 25 characters
The general parameters for the device are defined on this tab.
Device
Device name
Selection of a device from those available in the device table. The only
devices which shall be offered are those with which the command can
run.
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start
of the method.