Metrohm tiamo 2.3 Patch 1 - Manual (Page 1212)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1196 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1
￭ General/Hardware
Parameters for device and dosing device.
￭ Parameters
Parameters for adjusting the Liquid Handling function.
Command variables
The following command variables are generated in the method run by the
command LQH and can be used in formulas under the designation 'Com-
mand name.Variable designation':
Identifica-
tion Description
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command has
not ever been started
.CONC Concentration of the solution used for the command
.CYL Cylinder volume of the exchange or dosing unit used for
the command
.FIN Command status; 1 = Command has been ended at
least once, 0, invalid (variable not available) = Com-
mand has never been ended
.TITER Titer value of the solution used for the command
.VOL Currently dosed volume
5.6.6.4.2 LQH - General/Hardware
Tab: Method ▶ LQH ▶ Properties... ▶ General/Hardware
Command name
Name of the command.
Input 25 characters
The general parameters for the device and for the dosing device are
defined on this tab.
Device
Device name
Selection of a device from those available in the device table. The only
devices which shall be offered are those with which the command can
run.
Selection 'Device name' | not defined
Default value not defined