Metrohm tiamo 2.3 Patch 1 - Manual (Page 56)

2.4 Formula editor ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
40 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1
Designation Description Commands
.BLV Blank value for the sensor used
for the command (only for ISE
sensor) and/or blank value calcula-
ted from the calibration (for CAL
LOOP Conc) DET U, MET U,
SET U, STAT U,
MEAS U, MEAS
Conc, CAL LOOP
Conc, DOS U
.BP{x}.CNT Intensity for the break point x
(1…9) in counts MEAS Opt
.BP{x}.DME Measured value differential for the
break point x (1…9) MET
.BP{x}.ERC ERC or first derivative for the
break point x (1…9) DET
.BP{x}.MEA Measured value for the break
point x (1…9) in the unit of the
measured value DET, MET, MEAS
(without T/Flow,
Ref, Spec)
.BP{x}.TEM Temperature for the break point x
(1…9) in °C DET, MET, MEAS
(without T/Flow,
Ref, Spec)
.BP{x}.TIM Time for the break point x (1…9)
in s DET, MET, MEAS
(without T/Flow,
Ref, Spec)
.BP{x}.TRN Transmission for the break point x
(1…9) in % MEAS Opt
.BP{x}.VOL Volume for the break point x (1…
9) in mL DET, MET
.BSY Command status; 1 = BUSY,
HOLD or ERROR; 0 = READY;
invalid (variable not available) =
Command has never been started All except START
and END
.C0 Coefficient c0 of the calibration
curve CAL Spec, CAL
LOOP Opt
.C1 Coefficient c1 of the calibration
curve CAL Spec, CAL
LOOP Opt
.C2 Coefficient c2 of the calibration
curve CAL Spec, CAL
LOOP Opt
.C3 Coefficient c3 of the calibration
curve CAL Spec, CAL
LOOP Opt