Metrohm tiamo 2.3 Patch 1 - Manual (Page 1075)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.3 Patch 1 ￭￭￭￭￭￭￭￭ 1059
Range 0.25 ... 999999.0 s
Default value 2.0 s
Stop measured value
Stop when the entered measured value has been reached since the start
of the measurement.
Range 0 ... 4000 mAU
Selection off
Default value off
Temperature (089 Photometer)
Temperature
Measuring temperature which can be entered manually. If the Tempera-
ture measurement is set on the General/Hardware tab under Sensor
to continuous, then the temperature will be measured continuously.
Range 20.0 ... 60 °C
Default value 25.0 °C
5.6.4.15.4 MEAS Opt Conc - Additional measured values
Tab: Method ▶ MEAS Opt Conc ▶ Properties... ▶ Additional measured values
Command name
Name of the command.
Input 25 characters
A maximum of 6 additional measured values can be defined on this tab
which can then be saved together in additional measured value columns
with the measured values present in the default settings.
Additional calculated measured values
Additional calculated measured values
on | off (Default value: off)
If this option is enabled, then a maximum of 3 new measured values can
be calculated from existing measured values and saved, which can also be
presented as curves under the designation Calculated 1…3 and used in
formulas as variables 'Command name.CA1…3'.
[New]
Open the dialog window Calc. measured value # in which the parame-
ters for the additional measured value can be entered (see Chapter
5.6.3.11.1, page 930).