Metrohm tiamo 2.3 Patch 1 - Manual (Page 476)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
460 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1
5.6.3.2.2 DET pH
5.6.3.2.2.1 DET pH - Overview
Dialog window: Method ▶ DET pH ▶ Properties.. ▶ DET pH - 'Command name'
Command for Dynamic equivalence point titrations with potentio-
metric pH measurement.
Instruments
This command can be executed with the following devices:
Titrando: 808, 809, 835, 836, 857, 888, 904, 905, 906, 907
Titrino: 716, 721, 736, 751, 785, 794, 798, 799
Robotic Titrosampler: 855
Appearance
The command has the following appearance:
Parameters
The parameters for the command DET pH are configured on the follow-
ing 7 tabs:
￭ General/Hardware
Parameters for devices, dosing devices, sensors and stirrers.
￭ Start conditions
Parameters for the measurement of the initial measured value and for
defining the conditions which have to be met at the start of the titra-
tion.
￭ Titration parameters
Parameters for the run of the titration.
￭ Stop conditions
Definitions of conditions which cause the stop of the titration.
￭ Potentiometric evaluation
Parameters for the potentiometric evaluation of titration curves.
￭ Additional evaluations
Definition of additional methods for the evaluation of the titration
curves.
￭ Additional measured values
Definition of additional measured values of other measuring com-
mands which are saved as additional columns in the measuring point
list.