Metrohm tiamo 2.3 Patch 1 - Manual (Page 826)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
810 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1
command, a check is made of the working life, the validity of the titer and
the GLP test interval for the selected solution.
Input 24 characters
Selection 'Solution name' | not defined
Default value not defined
not defined
No tests will be carried out.
Sensor
Measuring input
Selection of the measuring input the sensor is connected to.
Titrando (without 890)
Selection
1 | 2
Default value 1
890
Selection
1
Default value 1
Sensor
Selection of a sensor of type Metal electrode from the sensors config-
ured in the sensor table. The calibration data for the sensor will be adop-
ted for the determination.
Selection Sensor name | Metal electrode
Default value Metal electrode
U(pol)
The polarization voltage is the voltage applied to the polarized electrode
during an amperometric measurement.
Titrando
Range
-1250 ... 1250 mV (Increment: 25)
Default value 400 mV
Titrino
Range
-1270 ... 1270 mV (Increment: 10)
Default value 400 mV
Electrode check
on | off (Default value: off)
If this check box is enabled, then an electrode check will be carried out for
polarizable electrodes during the transition from an inactive normal status