Metrohm tiamo 2.3 Patch 1 - Manual (Page 62)

2.4 Formula editor ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
46 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1
Designation Description Commands
.HP{x}.VOL Volume for the HNP x (1…9) in
mL DET, MET
.IGF Initial gas flow (measured value at
the time of the start of the com-
mand) in mL/min MEAS T/Flow
.IME Initial measured value (measured
value before start conditions are
processed) in the unit of the
measured value DET, MET, SET,
KFT, KFC, BRC,
STAT, MEAS
(without Ref,
Spec), CAL Cond,
CAL MEAS,
STDADD, DOS,
ELT MEAS
.ITE Initial temperature (temperature
before start conditions are pro-
cessed) in °C DET, MET, SET,
KFT, KFC, BRC,
STAT, MEAS
(without T/Flow,
Ref, Spec), CAL
MEAS, STDADD,
DOS, ELT MEAS
.IVE Value of the input at the end of
the command. CONTROL
.IVS Value of the input at the start of
the command. CONTROL
.LCO Loop counter = current quantity
of completed runs, both of
Repeat loops and of While loops LOOP, CAL LOOP,
ELT LOOP
.LP.CAx Calculated value x (1…3) for the
last measuring point on the meas-
uring point list DET, MET, SET,
KFT, KFC, BRC,
STAT, MEAS
(without Ref,
Spec, Opt), DOS
.LP.CHA Charge for the last measuring
point of the measuring point list
in mA s KFC, BRC
.LP.CNT Intensity of the last measuring
point on the measuring point list
in counts MEAS Opt, MEAS
Opt Conc, CAL
MEAS Opt