Metrohm tiamo 2.3 Patch 1 - Manual (Page 907)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.3 Patch 1 ￭￭￭￭￭￭￭￭ 891
Designation Description
.MR.MRT Mean dosing rate for the whole range in mL/min.
.MTE Temperature measurement with sensor; 1 = on, 0 =
off)
.NMP Number of measuring points in measuring point list
.RE{x}.DRC Correlation coefficient for mean dosing rate in window
× (1…9)
.RE{x}.DRS Standard deviation for mean dosing rate in window ×
(1…9) in mL/min
.RE{x}.DRT Mean dosing rate in window × (1…9) in mL/min
.RE{x}.RWL Lower limit of the evaluation window × (1…9) in s
.RE{x}.RWH Upper limit of the evaluation window × (1…9) in s
.SLO Electrode slope of the sensor used for the command (in
mV for ISE sensors)
.SME Start measured value (measured value after processing
the start conditions) in the unit of the measured value
.STE Start temperature (temperature after processing of the
start conditions) in °C
.STY Type of stop with which the command was stopped: 1
= normal; 0 = manual or after error
.SVA Start volume absolute (volume that was added accord-
ing to the start condition "start volume") in mL
.SVT Total start volume (volume that was added in depend-
ence on all three start conditions) in mL
.TITER Titer value of the solution used for the command
5.6.3.8.7.2 STAT U - General/Hardware
Tab: Method ▶ STAT U ▶ Properties... ▶ General/Hardware
Command name
Name of the command.
Input 25 characters
The general parameters for the control device, the dosing device, the sen-
sor and the stirrer are defined on this tab.