Metrohm tiamo 2.3 Patch 1 - Manual (Page 1394)

6.6 Subwindow Titrants/Solutions ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1378 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1
[Limits]
Open the dialog window Limits for titer, in which the warning and inter-
vention limits can be defined for the titer (see Chapter 6.6.3.5, page
1378). These limits apply only to the graph, no monitoring is carried out
during the titer determination.
[Delete history]
Delete the titer history.
6.6.3.5 Titer history Limit values
Dialog window: Configuration ▶ Titrants/solutions ▶ Properties ▶ Titer his-
tory ▶ [Limit values] ▶ Limit values titer
Warning and intervention limits can be defined for the titer in the dialog
window Limits for titer. If you have defined limits then these will be
shown in the graph in orange for warning limits and red for intervention
limits. Whether these limits are observed is not monitored, i.e. if the limits
are exceeded no action will be taken and these solutions can be used in
determinations.
Warning limits for titer
on | off (Default value: off)
If this option is activated, then the titer value will be shown in orange if
these limits are exceeded.
Lower limit
Lower warning limit.
Input 10 digits
Default value 0.9750
Upper limit
Upper warning limit.
Input 10 digits
Default value 1.0250
Intervention limits for titer
on | off (Default value: off)
If this option is activated, then the titer value will be shown in red if
these limits are exceeded.
Lower limit
Lower intervention limit.
Input 10 digits
Default value 0.9500