Metrohm tiamo 2.3 Patch 1 - Manual (Page 801)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.3 Patch 1 ￭￭￭￭￭￭￭￭ 785
￭ Additional measured values
Definition of additional measured values of other measuring com-
mands which are saved as additional columns in the measuring point
list.
Command variables
The following command variables are generated in the method run by the
command KFT Ipol and can be used in formulas under the designation
'Command name.Variable designation':
Designation Description
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command
has never been started
.CBY Command status; 1 = Conditioning activated, 0 =
Conditioning deactivated
.COK Command status; 1 = Condition requirement fulfil-
led, 0 = Condition requirement not fulfilled
.CONC Concentration of the solution used for the command
.CYL Cylinder volume of the exchange or dosing unit used
for the command
.DBL Total duration for the processing of the command in s
.DRI Current and/or last drift for drift correction in µL/min
.DSC Time for processing all start conditions s
.DTI Time for drift correction (time from the start of the
titration to the end of the command) in s
.EME End measured value (measured value after processing
of the command) in the unit of the measured value
.EP.MEA Measured value for the endpoint in the unit of the
measured value
.EP.MEP Quantity of endpoints 1 = 1 endpoint, 2 = 2 or
more endpoints, 3 = EP corrected with Auto-
drift, 4 = EP corrected with manual drift
.EP.TEM Temperature for the endpoint in °C
.EP.TIM Time in s until the endpoint is reached
.EP.VOL Volume for the endpoint in mL
.ETE End temperature (temperature following processing of
the command) in °C