Metrohm tiamo 2.3 Patch 1 - Manual (Page 1113)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.3 Patch 1 ￭￭￭￭￭￭￭￭ 1097
The general parameters for the device, the sensor and the stirrer are
defined on this tab.
Device
Device name
Selection of a device from those available in the device table. The only
devices which shall be offered are those with which the command can
run.
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start
of the method.
Device type
Display or selection of the device type.
Selection 712 Conductometer | 856 Conductivity Mod-
ule
Default value 856 Conductivity Module
Sensor
Sensor
Selection of a conductivity sensor from the conductivity sensors available
in the sensor table.
Selection 'Sensor name' | Conductivity sensor
Default value Conductivity sensor
Temperature measurement
Type of temperature measurement.
856
Selection
continuous | automatic | off
Default value automatic
continuous
A temperature sensor must be connected. The temperature will then
be measured continuously.
automatic
If a temperature sensor is connected then the temperature will be
measured continuously. Otherwise, the temperature entered manually
under Temperature on the Measuring parameters tab will be
used.