Metrohm tiamo 2.3 Patch 1 - Manual (Page 1246)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1230 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1
Cancel determination and series
The determination as well as the series will be canceled, then the exit
track (if present) will be started
Heater (Photometer)
Target temperature
Temperature to which the cuvette has to be heated. With Init.temp. the
cuvette heating is switched on at the same time as the device and the
cuvette is heated up to this temperature.
This value is live editable.
The initial temperature is defined in the device configuration.
Range 20 ... 80 °C
Selection Init.temp. | off
Default value Init.temp.
Init.temp.
With Init.temp. the cuvette heating is switched on at the same time
as the device and the cuvette is heated up to this temperature. The ini-
tial temperature is entered and altered in tiamo.
off
Switch off the heater.
5.6.7.9 FLOW
5.6.7.9.1 FLOW - Overview
Dialog window: Method ▶ FLOW ▶ Properties... ▶ FLOW - 'Command name'
Command for controlling the gas flow.
Devices
This command can be executed with the following devices:
Sample Processor: 774, 874
Appearance
The command has the following appearance:
Parameters
The parameters for the command FLOW are configured in the following
dialog window:
￭ FLOW - Properties