Metrohm tiamo 2.3 Patch 1 - Manual (Page 477)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.3 Patch 1 ￭￭￭￭￭￭￭￭ 461
Command variables
The following command variables are generated in the method run by the
command DET pH and can be used in formulas under the designation
'Command name.Variable designation':
Designation Description
.BP{x}.ERC ERC or first derivative for the break point × (1…9)
.BP{x}.MEA Measured value for the break point × (1…9) in the unit
of the measured value
.BP{x}.TEM Temperature for the break point × (1…9) in °C
.BP{x}.TIM Time for the break point × (1…9) in s
.BP{x}.VOL Volume for the break point × (1…9) in mL
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command
has never been started
.CONC Concentration of the solution used for the command
.CYL Cylinder volume of the exchange or dosing unit used
for the command
.DBL Total duration for the processing of the command in s
.DSC Time for processing all start conditions s
.EME End measured value (measured value after processing
of the command) in the unit of the measured value
.ENP Electrode zero point of the sensor used for the com-
mand (dimensionless)
.EP{x}.ERC ERC for the endpoint × (1…9)
.EP{x}.MEA Measured value for the endpoint × (1…9) in the unit of
the measured value
.EP{x}.MEP Quantity of endpoints in the window × (1…9); 1 = 1
endpoint, 2 = 2 or more endpoints, 3 = EP cor-
rected with Autodrift, 4 = EP corrected with
manual drift
.EP{x}.TEM Temperature for the endpoint × (1…9) in °C
.EP{x}.TIM Time in s until the endpoint × (1…9) is reached
.EP{x}.VOL Volume for the endpoint × (1…9) in mL