Metrohm tiamo 2.3 Patch 1 - Manual (Page 1060)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1044 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1
Stirring rate
Setting the stirring rate.
Range 0 ... 15
Default value 3
Switch off automatically
on | off (Default value: on)
If this check box is activated, the stirrer will be switched off automatically
when the command has finished.
5.6.4.14.3 MEAS Opt - Measuring parameters
Tab: Method ▶ MEAS Opt ▶ Properties... ▶ Measuring parameters
Command name
Name of the command.
Input 25 characters
The parameters for the measuring procedure can be defined on this tab.
Measuring parameters for the Avantes spectrometer
Wavelength
Wavelength at which the measured quantity (absorbance) is recorded.
Range 100.0 ... 2000.0 nm
Default value 400.0 nm
Blank value
Value by which the measured quantity (absorbance) is corrected. Here an
expression can also be entered through the formula editor (e.g. xx.EME
from other measuring command) by which every measured absorbance
value can then be corrected.
Range -4000 ... 4000 mAU
Default value 0 mAU
Integration time
Integration time for adsorption measurement.
Range 0.01 ... 600000 ms
Default value 6 ms
Averaged spectra
The number of spectra that are recorded and averaged.