Metrohm tiamo 2.3 Patch 1 - Manual (Page 411)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 4 Database
tiamo 2.3 Patch 1 ￭￭￭￭￭￭￭￭ 395
no symbol
Measuring points are not shown.
Note
With curves, for which the distance between two measuring points is
smaller than 5 pixels, the individual measuring points are not displayed
anymore, even if a symbol has been selected. In this case, the graphics
window can perhaps be enlarged in order to display the symbols again.
Symbol color
Selection of the color for the measuring point symbol.
Not editable for MEAS Ref and MEAS Spec commands
Selection
13 colors | pink
Default value pink
Smoothing
Smoothing
on | off (Default value: on)
Activates/Deactivates smoothing for the curve.
Smoothing factor x axis
Factor for smoothing on the x axis.
Range 0.01 ... 1000
Default value 0.01
Smoothing factor y-axis
Factor for smoothing on the y axis.
Range 0.01 ... 1000
Default value 0.01
4.8.4.5 Curve properties - Options
Tab: Database ▶ Curves ▶ Properties curves # ▶ Options
Options for the graphical display of curves.
Command type
Selection of the command type for which the curve properties are to be
defined. The curve properties defined for each command type are saved
per curve window and per client.