Metrohm tiamo 2.3 Patch 1 - Manual (Page 404)

4.8 Subwindow Curves ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
388 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1
Note
When the dialog window is opened, those Command type will be
selected per default which applies for the curve shown in the curve
window.
Autoscaling
on | off (Default value: on)
If this option is switched on then all axes in the curve window will be
scaled automatically. In this case the fields Start value and End value
cannot be edited.
Quantity
Selection of the quantity to be shown on the y1 axis.
For DET commands
Selection
Volume [mL] | Measured value | ERC | Time [s] |
Temperature [°C] | Calculated 1...3 | External
1...3
Default value Measured value
For MET commands
Selection
Volume [mL] | Measured value | dMW | Time
[s] | Temperature [°C] | Calculated 1...3 | Exter-
nal 1...3
Default value Measured value
For SET, STAT, DOS and KFT commands
Selection
Time [s] | Measured value | Volume [mL] | dV/
dt [µL/min] | Temperature [°C] | Calculated
1...3 | External 1...3
Default value Volume [mL]
For KFC commands
Selection
Time [s] | Measured value | Amount [µg] |
Charge [mAs] | Drift [µg/min] | dV/dt [µ/min] |
Ugen | Igen [mA] | Calculated 1...3 | External
1...3
Default value Amount [µg]