Metrohm tiamo 2.3 Patch 1 - Manual (Page 1018)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1002 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1
5.6.4.8.2 MEAS T/Flow - General/Hardware
Tab: Method ▶ MEAS T/Flow ▶ Properties... ▶ General/Hardware
Command name
Name of the command.
Input 25 characters
The general parameters for the device are defined on this tab.
Device
Device name
Selection of a device from those available in the device table. The only
devices which shall be offered are those with which the command can
run.
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start
of the method.
Device type
Display or selection of the device type. If a device is selected under Device
name, then this Device type field can no longer be edited, and the
device type belonging to the selected device is displayed instead
If the option not defined is selected as Device name, any device types
or device groups which are able to execute the command can be selected,
independently of the devices in the device table.
Selection 774 Oven Sample Processor | 874 Oven Sam-
ple Processor
Default value 874 Oven Sample Processor
5.6.4.8.3 MEAS T/Flow - Measuring parameters
Tab: Method ▶ MEAS T/Flow ▶ Properties... ▶ Measuring parameters
Command name
Name of the command.
Input 25 characters
The parameters for the measuring procedure can be defined on this tab.
Measuring time
Maximum period of time for measurement.