Metrohm tiamo 2.3 Patch 1 - Manual (Page 152)

3.6 Subwindow Run ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
136 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1
Note
When a new statistics series is started, the setpoint counter will be reset
to the value defined in the START command.
3.6.3.5 Single determination - Sample data
Tab: Workplace ▶ Run ▶ Single determination
Method
Entry or selection of the method from the current method group with
which the determination is to be carried out. By typing in the first charac-
ters, the method selection is continuously restricted and allows fast select-
ing of the method required.
Input 50 characters
Selection Method selection
Open the dialog window Open method for the extended method selec-
tion. If a method is selected in this window from a method group other
than the current one, then this group will henceforth be the current
method group for the quick selection of methods in the Method field.
This button is active only if more than one method group is present.
Note
If a method is changed and saved in the method editor or during
reprocessing, then the latest method version will be loaded when a
new determination is started.
Note
The following sample data fields can no longer be edited if they were
defined as Fixed value in the method (see Chapter 5.6.2.2.5, page
447).
Sample position
Position of the sample on the rack. This number is used to move to the
sample position with the command MOVE. For this to be achieved, the
Sample position option must be set under Target for the Move para-
meter.