Metrohm tiamo 2.3 Patch 1 - Manual (Page 1058)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1042 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1
Designation Description
.LP.TRN Transmission of the last measuring point of the
measuring point list in %
.MA{#}.[MEA] Maximum measured value in the unit of the meas-
ured value
.MA{#}.CNT Intensity for maximum measured value in counts
.MA{#}.TEM 1) Temperature for minimum measured value in °C
.MA{#}.TIM Time for the minimum measured value in s
.MA{#}.TRN Transmission for maximum measured value in %
.MI{#}.[MEA] Minimum measured value in the unit of the meas-
ured value
.MI{#}.CNT Intensity for minimum measured value in counts
.MI{#}.TEM 1) Temperature for minimum measured value in °C
.MI{#}.TIM Time for the minimum measured value in s
.MI{#}.TRN Transmission for minimum measured value in %
.MTE Temperature measurement with sensor; (1 = on, 0 =
off)
2)
.NMP Number of measuring points in measuring point list
.STY Type of stop with which the command was stopped:
1 = normal; 0 = manual or after error
1) Command variable is invalid for the Avantes spectrometer
2) For the Avantes spectrometer, MTE always equals 0
5.6.4.14.2 MEAS Opt - General/Hardware
Tab: Method ▶ MEAS Opt ▶ Properties... ▶ General/Hardware
Command name
Name of the command.
Input 25 characters
The general parameters for the device are defined on this tab.
Device
Device name
Selection of a device from those available in the device table. The only
devices which shall be offered are those with which the command can
run.