Metrohm tiamo 1.3 Manual - Manual (Page 816)

790 Configuration
6.7.3 Sensor properties
Edit properties
With the menu item Edit, Properties... in the subwindow Sensors the properties win-
dow for the sensor selected in the sensor table opens in which the parameters of
the sensor can be edited. It consists of the following tabs:
• Sensor
General information about the sensor, such as sensor name, sensor type,
start up, etc.
• Calibration data
Information about calibration of the sensor.
• Limits
Definition of limits monitoring for slope and electrode zero point.
•
History
Shows the last 10 calibration values.
Sensor
Sensor name
24 characters
Name of the sensor.
Note
The sensor name for the 5 non deletable default sensors
pH electrode , Metal e-
lectrode , ISE electrode , Temperature sensor and Conductivity sensor cannot be
changed.
Sensor type
Shows the type of sensor. Intelligent sensors are marked additionally with
IS .
Ion
Shows the ion to be measured and its valency. This parameter only ap-
pears for
ISE electrodes .