Metrohm tiamo 1.3 Manual - Manual (Page 492)

466 Method
Sensor
Sensor name, [ Metal electrode ]
Selection of a sensor of type pH electrode, Metal electrode or ISE electrode
from the list of sensors defined in the sensor table. The calibration data for
the ISE and pH sensors will be adopted for the determination.
Temperature measurement
Type of temperature measuring (only Titrando):
continuous
A temperature sensor must be connected. The temperature is measured
continuously.
[ automatic ]
If a temperature sensor is connected then the temperature will be meas-
ured continuously. Otherwise the manually entered
Temperature (tab Titra-
tion parameters ) will used.
off
The temperature will not be measured. The Temperature (see Titration pa-
rameters) which has been entered manually will be used.
Stirrer
Stirrer
[ 1 ] ... 4, off (only Titrando)
Selection of the stirrer. off means that no stirrer will be used.
Stirring rate
-15 ... [ 8 ] ... 15 (only Titrando)
Setting the stirrer speed. The direction in which stirring takes place changes
as the sign in front of the stirrer speed changes.
Switch off automatically
[ on ], off (only Titrando)
If this option is enabled, the stirrer will be switched off automatically when
the command is finished.
Switch on/off automatically
[ on ], off (only 751, 799)
If this option is enabled, the stirrer will be switched on automatically at the
start of the command and will be switched off automatically at the end of
the command.
Start conditions
Screenshot and parameters: see STAT pH - Start conditions