Metrohm tiamo 1.3 Manual - Manual (Page 780)

754 Configuration
Unit for gas flow
Shows the unit selected at the device for the gas flow display ( mL/min or
L/h ).
Minimum gas flow
Shows the lower warning limit set on the device for the gas flow.
Maximum gas flow
Shows the upper warning limit set on the device for the gas flow.
Gas type
Shows the carrier gas.
Correction factor
Shows the correction for the gas flow measurement with "other" gases.
Note
If the minimum gas flow is undercut or the maximum gas flow is exceeded then
an error message will appear.
RS 232
COM Port
COM1, COM2, ..., [ first free COM port ]
Selection of the serial interface on the PC to which the device is connected.
Baud rate
1200, 2400, 4800, [ 9600 ]
Transmission speed. Additionally, this baud rate must be set on the device
itself.
Note
Thes parameters are only editable for devices with status not ok (power and/or
RS connection interrupted).