Metrohm tiamo 1.3 Manual User Manual
Page 52

26
General program functions
Identifier
Description
Commands
.RE{x}.DRC
Correlation coefficient for mean dosing rate in window x (1...9)
STAT
.RE{x}.DRS
Standard deviation for mean dosing rate in window x (1...9) in
mL/min
STAT
.RE{x}.DRT
Mean dosing rate in window x (1...9) in mL/min
STAT
.RE{x}.RWL
Lower limit of evaluation window x (1...9) in s
STAT
.RE{x}.RWH
Upper limit of evaluation window x (1...9) in s
STAT
.RES
Calculated result for standard addition in selected unit
STDADD
.RPO
Current rack position (entry at end of command); 0 means 'not
defined'
MOVE
.SAN
Current absolute swing angle of the swing head in ° (entry at
end of command)
MOVE, SWING
.SLO
Electrode slope of the sensor used for the command (in % for
pH sensor or mV for ISE sensor) or the electrode slope calcu-
lated from the calibration (for STDADD and CAL LOOP)
DET pH, DET U,
MET pH, MET U,
SET pH, SET U,
STAT, MEAS pH,
MEAS U, MEAS T,
MEAS Conc,
STDADD, CAL
LOOP, DOS
.SME
Starting measured value (measured value after processing the
start conditions) in the units of the measured value
DET, MET, SET,
KFT, KFC, STAT
.SPO
Current external position (entry at end of command); 0 means
invalid position
SWING
.STE
Start temperature (temperature after processing the start con-
ditions) in °C
DET, MET, SET,
KFT, KFC, STAT
.STY
Stop type with which the command has been stopped: 1 =
normal;0 = manual or after error
DET, MET, SET,
KFT, STAT, MEAS,
CAL MEAS,
STDADD, DOS
.SVA
Start volume absolute (volume added in accordance with the
start condition "Start volume") in mL
DET, MET, SET,
KFT, STAT
.SVM
Start volume measured value (volume added in accordance
with the start condition "Start measured value") in mL
DET, MET
.SVS
Start volume measured value (volume added in accordance
with the start condition "Start slope") in mL
DET, MET
.SVT
Start volume total (volume added in accordance with all three
start conditions) in mL
DET, MET, SET,
KFT, STAT
.TITER
Titer value for the solution used for the command
DET, MET, SET,
KFT, STAT,
STDADD dos,
STDADD auto,
ADD, DOS, LQH
.TOU
Timeout status: 1 = max. delay period elapsed; 0 = max.
delay period not elapsed
RECEIVE, TRANS-
FER; SCAN
.VAR
Variance of the calculated standard addition result in selected
unit
STDADD
.VOL
Added volume
STDADD, ADD,
DOS, LQH