Metrohm tiamo 1.3 Manual - Manual (Page 144)

118 Workplace
Arrangement ID1...8
1 column
[ on ], off
If this option is switched on then the sample identifications ID1...ID8 are
displayed in a single column.
2 columns
on, [ off ]
If this option is switched on then the sample identifications ID1...ID8 are
displayed in two columns.
Note
The fields
Sample size and Sample size unit are always shown in one line horizon-
tally.
Process
Options for processing single determinations.
Method selection by assignment ID
on, [ off ]
[ ID1 ] ... ID8
If this option is switched on then the selected sample identification for the
method selection will be used. This identification contains the descriptive
Assignment ID that can no longer be edited. If this ID agrees with one of the
assignment IDs in the Sample assignment table then the corresponding
method will be entered in the field
Method from this table.
Request assignment ID
on, [ off ]
If this option is switched on then the Assignment ID will be requested directly
after the start of the determination in the dialog window Sample assignment
(see Workplace - Tools - Sample assignment table - Sample assignment re-
quest).
Autorepeat determination
on, [ off ]
If this option is switched on then at the end of a determination the next de-
termination with the same method will be started automatically. In order to
stop the autorepeat the determination has to be stopped with
[Stop] .