Metrohm tiamo 1.3 Manual - Manual (Page 512)

486 Method
Sensor
Measuring input
[ 1 ] ... 2 (Titrando)
[ 1 ] ... 2, diff. (Titrino)
Selection of the measuring input to which the sensor is connected.
Sensor
Sensor name, [ pH electrode ]
Selection of a sensor of type pH electrode from the list of sensors defined in
the sensor table.
Temperature measurement
Type of temperature measurement (Titrando only):
continuous
A temperature sensor must be connected. The temperature is then meas-
ured continuously.
[ automatic ]
If a temperature sensor is connected, the temperature will be measured
continuously. Otherwise the temperature manually entered under Tempera-
ture (see Measuring parameters) will be used.
off
The temperature will not be measured. The temperature manually entered
under
Temperature (see Measuring parameters) will be used.
Stirrer
Stirrer
[ 1 ] ... 4, off (Titrando only)
Selection of the stirrer. off means that no stirrer will be used.
Stirring rate
-15 ... [ 8 ] ... 15 (Titrando only)
Setting the stirrer speed. The direction in which stirring takes place changes
as the sign in front of the stirrer speed changes.
Switch off automatically
[ on ], off (Titrando only)
The stirrer is automatically switched off at the end of the command if this
option is enabled.